Cylon V5 – Production Ready

This is the final update to the schematics and overall design and concludes the R&D aspects of the project. What I have now is a good mix of design good practice and intelligent thinking that results in a solid architecture for a run. So far I have just prototyped the design into the car using readily available breadboards, however, the next step is to move to a manufactured circuit board that will give much better longevity and easier assembly.

Content relocated to Project Page

4 Replies to “Cylon V5 – Production Ready”

  1. Hi, first of all I’de like to say that I love your project.
    I have an Alfa Romeo 159 SW, can this applly to the SW?
    If so, can you sell it?
    Thanks in advance.

  2. Hi, thanks for the compliment. Unfortunately, this is going to be 100% DIY, I have no intentions of making these or selling them as they were purely a vanity project. You could make you’re own from the code and designs here though, as I previously looked into doing it for the SW and its not dissimilar.

    Good Luck!

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.