Tag: audio

Posted on

159 Custom Bass Project โ€“ Stage 5 Wiring

The final stage was putting all the wiring in place. I opted for 4 gauge cable from the battery up front and a 4 gauge earth in the rear, both connected back to brass 4 way distribution blocks so I could pull 8 gauge runs to amps and the line converter. This also left me the easy upgrade route for adding additional amps to run upgraded mids & tweeters in the cabin, but that’s another project!! Continue reading “159 Custom Bass Project โ€“ Stage 5 Wiring”

Related Images:

Posted on

159 Custom Bass Project โ€“ Stage 4 Enclosure Build

Once the car was pepped and ready it was onto the enclosure build. This was a combination of trial and error mixed with some loose  calculations and estimations around box size. I had worked out utilising box design software that  for my sub, a 0.6 cuft sealed enclosure was going to give me good responsive SQ and enough power. This also suited my limited boot incursion requirements so was ideal. Continue reading “159 Custom Bass Project โ€“ Stage 4 Enclosure Build”

Related Images:

Posted on

159 Custom Bass Project โ€“ Stage 2 Amp Mods

I already had the amplifier and sub from a prior install, and in that install I had discovered a problem with the pairing. The sub is an Infinity Kapa perfect 12 VQ rated at 400w RMS and the amplifier is an Alpine MRV-420 rated at 350W RMS. Driving the sub at high voltage, with line levels in excess of 4v and the gains maxed out means that the amp is producing closer to 450W RMS and the sub, which is well regarded as being able to handle much higher loads than 400W RMS, just laps it up, but had one small issue that needed sorting. It would overheat during extended sessions of Drum and Bass at full power! To sort this issue, I stripped the amp back to bare metal, rebuilt it using high grade CPU heat sink paste and added a temperature controlled cooling system utilising 6 x 40mm fans in a push/pull config. Needless to say, it can run at full power and then some, all day long now ! Continue reading “159 Custom Bass Project โ€“ Stage 2 Amp Mods”

Related Images:

Posted on

Awesome Sounds Part II

Well, after the change of room size the RP6G2’s lack of low frequencies eventually pushed me to go the extra mile and get the KRK10s. Initial feedback on it? Its got so much bass! I know that’s the whole point of it, but wow, I like bass and even I struggle with this sometimes. So much so that I actually bought the Boss FS-5L latched foot switch so that I could bypass the sub from time to time and allow the full range of frequencies back to the RP6G2’s!!!! Continue reading “Awesome Sounds Part II”

Related Images: